METALLOGRAPHY

Faced with the constant evolution of the materials and the quality standards, LAM PLAN is a reference partner for the preparation of the samples for the metallographic analysis.

Our technical solutions and our customised methods will ensure you reliable and reproducible results. We are fully committed to the quality of the samples.

The LAM PLAN test laboratory will guarantee you a response adapted to your needs in surface preparation. This service relies on our range of innovative products and our in-depth experience of the various polishing and super finish trades.

METALLOGRAPHY

Cutting

Metallographically cutting off the part allows not only sampling the material, but also observing the material’s structure at a specific spot.

The preparation of metallographic samples requires a precision cutting off in a wide variety of materials.

A good lubrication is necessary to cool the cutting  wheel and prevent the burning of the parts. In addition, the environment of a metallography laboratory imposes cleanliness and safety criteria to which your cut-off equipment must comply.

All cutting products

  • CUTLAM®micro 1.1

  • CUTLAM®micro 2.0

  • CUTLAM®micro 3.0

  • CUTLAM®1.1

  • CUTLAM®3.1

  • CUTLAM®4.0

  • CUTLAM®5.0

  • Accessories CUTLAM®micro range

  • Accessories CUTLAM® range

  • Maintenance

  • Cutting wheels

    METALLOGRAPHY

    Mounting

    Embedding allows limiting edge stresses during the polishing step. This operation will also allow you:

    • In manual polishing: to facilitate the holding of the sample
    • In automatic polishing: to place several samples together in a sample holder under optimum tightening conditions

    All mounting products

    • PRESSLAM®1.1

    • M.M.806

    • M.M.886

    • Hot mounting resins

    • Cold mounting resins

    • Accessories

      METALLOGRAPHY

      Prepolishing & polishing

      Grinding and prepolishing are crucial steps in the preparation of a metallographic sample.

      It is the quality of these steps which will condition and optimise the rest of the process.

      At the end of the prepolishing step, the sample’s aspect must be uniform and regular without any alteration of the inherent flatness or the material.

      All prepolishing & polishing products

      • SMARTLAM©2.0
      • SMARTLAM©3.0
      • MASTERLAM©1.0
      • MASTERLAM©3.0
      • MASTERLAM©1.1
      • RECTILAM©2.0
      • Fluids & lubricants
      • Bio DIAMANT® abrasive suspensions
      • Finishing liquids
      • Bio DIAMANT® sticks & pastes
      • Accessories for polishing machines
      • Fixing accessories
      • Cleaning and storage accessories
      • Grinding and pre-polishing discs
      • Grinding and pre-polishing CAMEO®DISK
      • TOUCHLAM® polishing discs

        Assistance & information

        We will contact you

        Get a call from a LAM PLAN advisor.

        Call us

        For all your technical or commercial requests


        Our social networks

        • Lapping supports
        • Pre-polishing discs
        • Abrasive liquids
        • Polishing supports
        • Diamond polishing liquids
        • Diamond lapping liquids
        • Diamond superfinition products
        • Abrasive liquids

          All rights reserved © LAM PLAN SA 2019
          Made by : CtoutcomStudio

          Contact us

          LAM PLAN SA
          7, rue des Jardins - B.P.15
          74240 Gaillard - France
          header-receiver +33 (0)4 50 43 96 30

          Our dealers